Upgrade. big 3. 1/0 HPM.

[Loud16yrold]

Getting ready for a pretty big jump in power(new subs/new amp(s). So this is in preparation for a H/O alt and new battery. Picked up some stinger 1/0 saturday night and had to wait till this morning to wire it up.

http://img152.imageshack.us/img152/9225/1061071ro7.jpg (http://imageshack.us)
1/0 HPM and 1/0 stinger terminals.

http://img159.imageshack.us/img159/4798/0000004qn3.jpg
http://img69.imageshack.us/img69/2331/0000005mj0.jpg

engine to chassis is on the back of the block, ran out of memory so I didnt get a pic.

[mrwigglezdj]

what are youre new plans for your system

[StripperMan]

i would get a different battery if u wana use 1/0 wire. a red top altima will do. that stock battery will be dead in a month or 2.

[Chuck]

Get a Kinetik HC2400! You'll only need one unless you're plannin on goin with like 3,000rms+.

[Loud16yrold]

I cant fit a hc2400, I can fit a hc2000 tho. Im staying with 2 10" inch subs, but with 2000rms. Got a new job, makin' good money so I should have it done by new years.

I also built a new box to see if sub/port back is louder then sub up/port back. I dont know if its louder on the meter, but it definitely sounds different.

[NeillBarber]

a red top altima will do. .


Nissan makes good batteries?





NeillBarber

[Queball]

not as good as the camry battery

[KickinAudio]

not as good as the camry battery

x2!

[Chuck]

Run the 350Z battery. Everyone else does.

Anyways, the sub/port back probably sounds louder because off less cancellation.

Ans for 2,000rms a HC2000 would be just right. Could always run a smaller Kinetik up front, an a HC2000 or HC2400 in the rear as support so you wont have any voltage problems.