PDA

View Full Version : bagged 91 s10


NomaOnAir
01-05-2009, 07:53 PM
Bagged 91 s10

The bad .. It needs a new diff seal ,and drop spindles to lay in the front, also needs a alignment if you choose to do or not to do spindles , I never did it because I was planning on getting drop spindles soon an woulda been dumb to pay twice.. needs a roll pan or bumper gas tank in bed


bagged on all 4 corners..
slam re7 bags all around
( suicide doors cups up front , SD bridge kit on a mono leaf rear)
8- 3/8 s10 valves
all 1/2 line.. Dot fittings
eai 7 switch rocker switch box
Viair 450c ( 110-145 pressure switch)
The truck is plumbed/has guage(kp 1/2/2 needle) but they are not hooked up

It is paint flat baby blue witha couple of primer spots few small dings here an there.. It has shaved , antenna , handles , tailgate , suicide hood

no stereo , but it has fiberglass door pods for 2 - 6.5 per door , setup for a 4 channel up with tweeters in the dash on sep. channel , air guages fiberglassed into glove box door cover in micro suede along with door pods..

2.5L 5spd
New fuel pump , filter , injector , fpr , clutch master cylinder

Im asking $3600 obo ( OB REASONABLE CASH OFFER !)
Sorry for crappy picture
http://i22.photobucket.com/albums/b332/grillen85/PIC-0090.jpg
crappy picture of the truck , on 17 kmc hotwheels 2 tires are good , 2 are bad